One cable slipping off its drum groove is enough to jam a door mid-cycle or send a panel crashing at an angle. We fix the cable and check why it slipped in the first place.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
A cable can slip its groove repeatedly if the drum itself is damaged, which we check before calling the job done.
Our technicians are trained to safely release and reset tension when cables are involved, not just the springs.
We carry the common cable lengths and gauges for most residential door sizes.
Each service below is handled by a technician trained specifically for this kind of repair, not a generalist guessing at it.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
If the cable keeps slipping off the drum, we look for a bent drum or misaligned track causing the repeat issue.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Same-day fix on a Saturday, cable stock right there on the truck.”
One side losing tension while the other holds is the classic sign of a single cable or spring failure.
Both cables typically get replaced together to avoid a near-term repeat call.
Yes, a door hanging on a single cable or spring can drop unexpectedly and should not be operated until repaired.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
Standard cable and drum stock means same-visit repair is the norm, not the exception.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Salem to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Salem, SD